Where our valves are used

Tell us the support type and the working conditions, and we will match the series. If your equipment is not listed, send the drawing — custom production is routine for us.

Shield supports

Safety valves on the leg circuit, hydraulic locks for load holding, and directional control blocks for advancing, setting and lowering the support.

Emulsion pump stations

High-pressure filtration, pressure control and distribution for the emulsion circuit that feeds the supports.

Mining machinery

Auxiliary hydraulic circuits on crushers, loaders, belt equipment and other machinery used alongside the face.

Repair and replacement

Parts matched to an original part number, a competitor's part or a sample — the fastest route for a maintenance team that needs a face running again.

Other equipment

We supply hydraulics for powered roof supports and mining machinery. We do not supply valves for general industrial piping, domestic or automotive use — if your application is outside mining, we will say so honestly rather than waste your time.

Direct answers

Short, factual answers to the questions buyers and engineers ask most often. Each answer stands on its own.

What is a safety valve on a powered roof support?

It is a relief valve on the leg circuit. At a set pressure it opens and lets emulsion return to the tank, so the leg cannot be over-pressurised when the roof loads or the support yields. The set pressure is a safety-critical value and must be confirmed against the support specification, not copied from a similar part.

What is a hydraulic lock (pilot-operated check valve) used for on a support?

It holds the leg extended when the supply line is depressurised. A pilot line opens the check when the support is lowered. If a support creeps down slowly while the pump is running normally, the lock valve is the first part to check.

Which valve models does the factory hold mining product approval for?

The single lock valves FDD125/50 and FDD80/50, and the cone-type shut-off valve FJZ400/31.5, carry the MA mining product safety mark. The approval numbers are MEE131131 and MEE131132 for the lock valves. Confirm the covered model list against the certificate before ordering.

Is the working fluid emulsion or oil?

Powered roof supports run on a water-emulsion mixture, not hydraulic oil. That is why the valves are built with corrosion-resistant bodies and why filtration of the emulsion circuit matters as much as the valves themselves.

What does the number in FDD125/50 mean?

FDD designates the product family (pilot-operated check valve, single lock). The 125 and 50 are the model designations used on the nameplate. The exact meaning of each figure is confirmed against the drawing for that model — it is not inferred from the name here.

Can a replacement part be made without a drawing?

Yes, in most cases. Send the failed part and it is measured on a coordinate basis, a dimensioned drawing is reconstructed and sent for approval before manufacture. For simple parts such as a manifold block or a blanking plate, photographs with a rule across the ports are often enough to quote.

What is the minimum order quantity?

There is no minimum for a first trial order. A first order is typically a mixed batch of the parts a maintenance team consumes fastest, so quality can be judged before committing to volume.

How fast is a quotation?

Usually within one working day. Send the part number, a drawing or a photo of the nameplate together with working pressure and quantity.

Not sure which part failed?

Read how the circuit works — it walks from the pump station to the leg and names the parts that fail first.

How the circuit works